HS 250h L4-2.4L (2AZ-FXE) Hybrid (2010)
NOTICE:
Temporarily tighten bolt B, and then fully tighten the 2 bolts and 2 nuts in the order of C, E, D and B.
15. INSTALL FRONT SUSPENSION MEMBER REAR BRACE LH
(a) Install the front suspension member rear brace LH with the 3 bolts and clip.
Text in Illustration
Bolt A - Torque : 145 Nm (1479 kgf-cm, 107 ft-lbf)
Bolt B - Torque : 93 Nm (948 kgf-cm, 69 ft-lbf)
16. INSTALL FRONT SUSPENSION MEMBER REAR BRACE RH
HINT
Perform the same procedure as for the LH side.
17. INSTALL REAR SIDE RAIL REINFORCEMENT SUB-ASSEMBLY LH
(a) Install the rear side rail reinforcement sub-assembly LH with the 4 bolts.
Torque : 96 Nm (979 kgf-cm, 71 ft-lbf)
NOTICE:
Temporarily tighten bolts A and B, and then fully tighten the 4 bolts in the order of C, B, D and A.
18. INSTALL REAR SIDE RAIL REINFORCEMENT SUB-ASSEMBLY RH
HINT
Perform the same procedure as for the LH side.
19. CONNECT FRONT NO. 1 LOWER SUSPENSION ARM SUB-ASSEMBLY LH See: Wheel Hub/Service and Repair/Front Axle
Hub/Installation
20. CONNECT FRONT NO. 1 LOWER SUSPENSION ARM SUB-ASSEMBLY RH
HINT
Perform the same procedure as for the LH side.
21. CONNECT TIE ROD END SUB-ASSEMBLY LH See: Steering/Steering Gear/Service and Repair/Removal and Replacement/Installation
22. CONNECT TIE ROD END SUB-ASSEMBLY RH
HINT
Perform the same procedure as for the LH side.
23. CONNECT FRONT STABILIZER LINK ASSEMBLY LH
(a) Install the front stabilizer link assembly LH to the front stabilizer bar with the nut