HS 250h L4-2.4L (2AZ-FXE) Hybrid (2010)
Suspension Spring ( Coil / Leaf ): Service and Repair
Removal
REAR SUSPENSION: REAR COIL SPRING: REMOVAL
HINT
*
Use the same procedure for the RH side and LH side.
*
The procedure listed below is for the LH side.
1. REMOVE REAR WHEEL
2. REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY (w/ Height Control Sensor) See: Lighting and Horns/Headlamp/Headlamp
Alignment Sensor/Service and Repair/Removal
3. REMOVE REAR SUSPENSION ARM COVER See: Control Arm/Service and Repair/Rear Lower Arm/Removal
4. REMOVE REAR FLOOR SIDE MEMBER COVER LH (for LH Side) See: Control Arm/Service and Repair/Rear Lower Arm/Removal
5. REMOVE REAR FLOOR SIDE MEMBER COVER RH (for RH Side) See: Control Arm/Service and Repair/Rear Lower Arm/Removal
6. REMOVE REAR SUSPENSION MEMBER BRACE See: Stabilizer Bar/Service and Repair/Rear Stabilizer Bar/Removal
7. REMOVE REAR STABILIZER LINK ASSEMBLY See: Stabilizer Bar/Service and Repair/Rear Stabilizer Bar/Removal
8. REMOVE REAR COIL SPRING
(a) Support the rear axle assembly with a jack using a wooden block as shown in the illustration.
Text in Illustration
NOTICE:
Keep supporting the rear axle assembly with a jack until the installation of the rear coil spring has been completed.
(b) Support the rear No. 2 suspension arm assembly using a jack and wooden block.
Text in Illustration
(c) Loosen the bolt (A).