HS 250h L4-2.4L (2AZ-FXE) Hybrid (2010)
Text in Illustration
NOTICE:
Do not damage the outboard joint boot.
(d) For claw engagement type:
(1) Using needle-nose pliers, install a new front drive shaft damper clamp LH as shown in the illustration.
16. INSTALL FRONT DRIVE SHAFT DAMPER CLAMP RH
HINT
Perform the same procedure as for the front drive shaft damper clamp LH.
17. INSTALL FRONT DRIVE INBOARD JOINT ASSEMBLY LH
(a) Before installing the boot, wrap the splines of the front drive outboard joint assembly LH with protective tape to prevent the boot from being
damaged.
(b) Install new parts to the front drive outboard joint assembly LH in the following order (for one touch type):
Text in Illustration
(1) Install the front axle inboard joint boot clamp LH (A).
(2) Install the inboard joint boot (B).
(3) install the front No. 2 axle inboard joint boot clamp LH (C).
(c) Install a new inboard joint boot to the front drive outboard joint assembly LH (for claw engagement type):
Text in Illustration