HS 250h L4-2.4L (2AZ-FXE) Hybrid (2010)
Shift Selector Actuator: Service and Repair
Installation
P311 HYBRID TRANSMISSION / TRANSAXLE: SHIFT CONTROL ACTUATOR: INSTALLATION
1. INSTALL SHIFT CONTROL ACTUATOR ASSEMBLY
(a) Install the shift control actuator assembly with 3 new shift control actuator bolts.
Torque : 9.5 Nm (97 kgf-cm, 84 in-lbf)
(b) Install 3 new shift control actuator bolt caps to the shift control actuator bolts.
NOTICE:
Push in each shift control actuator cap firmly until the claw of the shift control actuator bolt cap engages with the control actuator
bolt.
2. INSTALL AUTOMATIC TRANSMISSION CASE COVER
(a) Install the automatic transmission case cover with the 2 bolts (B) and new clip.
Torque : 12 Nm (120 kgf-cm, 9 ft-lbf)
(b) Install the 2 oil cooler tube clamps with the 2 bolts (A).
Torque : 8.2 Nm (84 kgf-cm, 73 in-lbf)
(c) Connect the 2 connectors and clamp.
3. INSTALL REAR ENGINE UNDER COVER LH
4. INSTALL NO. 1 ENGINE UNDER COVER