HS 250h L4-2.4L (2AZ-FXE) Hybrid (2010)
Sensor/Removal
21. REMOVE ASSIST GRIP ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal and
Replacement/Removal
22. REMOVE VISOR BRACKET COVER (for LH Side) See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal
and Replacement/Removal
23. REMOVE VISOR ASSEMBLY LH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal and
Replacement/Removal
24. REMOVE VISOR BRACKET COVER (for RH Side) See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal
and Replacement/Removal
25. REMOVE VISOR ASSEMBLY RH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal and
Replacement/Removal
26. REMOVE VISOR HOLDER See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal and Replacement/Removal
27. REMOVE ROOF HEADLINING ASSEMBLY
(a) Slightly lower the front section of the roof headlining assembly so that the windshield glass can be removed.
HINT
It is not necessary to completely remove the roof headlining assembly.
28. REMOVE WINDSHIELD GLASS SUB-ASSEMBLY
(a) Apply protective tape to the installation position of the windshield glass on the vehicle body.
Text in Illustration
HINT
Apply protective tape to the area around installation surface to prevent it from being scratched.
(b) Pass a piano wire between the vehicle body and glass from the interior, as shown in the illustration.
Text in Illustration