lexus Workshop Repair Guides

Lexus Workshop Service and Repair Manuals

Engine - MIL ON/Multiple Misfire DTC's Stored In Memory|Page 2654 > < Engine - MIL ON/Multiple Misfire DTC's Stored In Memory|Page 2652
Page 5
background image

4. Remove the engine compartment side cover RH by removing the 2 clips.

5. Remove the V-bank cover sub-assembly.

Raise the V-bank cover to disengage the clip on the rear of the cover. Raise the cover again to disengage the 2 clips on the front of the cover and
remove the cover.

NOTE

Attempting to disengage both the front and rear clips at the same time may cause the cover to break.

6. Discharge the fuel system pressure.

FUEL SYSTEM CAUTIONS

^

Do NOT smoke or work near an open flame when working on the fuel system.

^

Keep gasoline away from rubber or leather parts.

^

Do NOT allow fuel to spray when removing the pipe between the high pressure side fuel pump and the fuel injector. The fuel in the pipe is highly
pressurized.

^

Wear safety goggles while working with fuel system under pressure.

^

Do NOT disconnect any part of the fuel system until you have discharged the fuel system pressure.

^

Even after discharging the fuel pressure, place a shop rag over fittings as you separate them to reduce risk of fuel spray on yourself or in the
engine compartment.

A. Disconnect the fuel pump connector.

B. Connect the cable to the negative (-) battery terminal.

C. Start the engine. After the engine has stopped on its own turn the engine switch OFF.

HINT

Engine - MIL ON/Multiple Misfire DTC's Stored In Memory|Page 2654 > < Engine - MIL ON/Multiple Misfire DTC's Stored In Memory|Page 2652