IS 250 AWD V6-2.5L (4GR-FSE) (2006)
^
Do not damage the ball joint dust cover.
^
Make sure that the SST is securely positioned on the steering knuckle spacer.
^
If the steering knuckle spacer has come off, replace the steering knuckle with a new one.
^
Make sure that the string of the SST is securely tied to the vehicle.
13. REMOVE STEERING KNUCKLE
a) Remove the clip and nut.
b) Using SST, remove the steering knuckle from the upper suspension arm.
SST 09628-00011
NOTICE:
^
Use caution not to damage the steering knuckle because it is made of aluminum and may be damaged easily.
^
Do not damage the ball joint dust cover.
^
Make sure that the SST is securely positioned on the steering knuckle spacer.
^
If the steering knuckle spacer has come off, replace the steering knuckle with a new one.
^
Make sure that the string of the SST is securely tied to the vehicle.
INSTALLATION
1. INSTALL STEERING KNUCKLE
a) Install the steering knuckle to the upper suspension arm with a nut.
Torque: 87 Nm (887 kgf-cm, 64 ft. lbs.)
b) Install a new clip.
NOTICE: If the holes for the clip are not aligned, further tighten the nut up to 60°.
2. INSTALL TIE ROD ASSEMBLY (for 4WD)