IS 250 RWD V6-2.5L (4GR-FSE) (2007)
c. Using a straight hexagon wrench 14 mm, install the cap to the cooler condenser core.
Torque: 2.9 N.m (30 kgf.cm, 26 in.lbf)
2. INSTALL COOLER CONDENSER ASSEMBLY
a. Install the cooler condenser assembly with the 4 bolts.
Torque: 5.0 N.m (51 kgf.cm, 44 in.lbf)
HINT: If the condenser is replaced with a new one, add compressor oil to the new condenser.
Capacity: 40 cc (1.4 fl. oz.)
Compressor oil: ND-8 or equivalent
3. INSTALL DISCHARGE HOSE SUB-ASSEMBLY
a. Remove the attached vinyl tape from the hose and the connecting part of the cooler condenser assembly.
b. Sufficiently apply compressor oil to a new O-ring and the fitting surface of the hose joint.
Compressor oil: ND-OIL 8 or equivalent
c. Install the O-ring on the discharge hose sub-assembly.
d. Install the discharge hose sub-assembly on the cooler condenser assembly with the bolt.
Torque: 5.4 N.m (55 kgf.cm, 48 in.lbf)
4. INSTALL LIQUID TUBE SUB-ASSEMBLY
a. Remove the attached vinyl tape from the pipe and the connecting part of the cooler condenser assembly.
b. Sufficiently apply compressor oil to a new O-ring and the fitting surface of the pipe joint.