IS 250 RWD V6-2.5L (4GR-FSE) (2007)
/Page-1009003.png)
a) Measure the resistance according to the value(s) in the table.
Standard Resistance
If the resistance value is not as specified, replace the speed sensor.
INSTALLATION
1. INSTALL TRANSMISSION REVOLUTION SENSOR (SP2 SENSOR)
a) Coat a new O-ring with ATF and install it to the transmission revolution.
b) Install the transmission revolution sensor with the bolt.
Torque: 5.4 Nm (55 kgf-cm, 48 inch lbs.)
c) Connect the transmission revolution sensor connector.
2. INSTALL TRANSMISSION REVOLUTION SENSOR (NT SENSOR)
a) Coat a new O-ring with ATF and install it to the transmission revolution.
b) Install the transmission revolution sensor with the bolt.
Torque: 5.4 Nm (55 kgf-cm, 48 inch lbs.)
c) Connect the transmission revolution sensor connector.
