IS 250 RWD V6-2.5L (4GR-FSE) (2007)
d) Tighten a new lock nut.
Torque: 28 Nm (286 kgf-cm, 21 ft. lbs.)
3. CONNECT FRONT UPPER SUSPENSION ARM
a) Install the steering knuckle to the front upper suspension arm, and secure them with the nut.
Torque: 87 Nm (887 kgf-cm, 64 ft. lbs.)
b) Install a new clip to the steering knuckle.
NOTICE:
^
Further tighten the nut up to 60° if the holes for the cotter pin are not aligned.
^
Do not loosen the nut to align the holes for the cotter pin.
4. CONNECT FRONT SPEED SENSOR
a) Install the front speed sensor to the front shock absorber with coil spring with the 2 bolts.
Torque: 6.0 Nm (61 kgf-cm, 4.4 ft. lbs.)
NOTICE:
^
Do not twist the front speed sensor while installing it.
^
Be careful not to deform the bracket of the front shock absorber with coil spring when installing the bolts.
5. CONNECT FRONT STABILIZER LINK ASSEMBLY