IS 250 RWD V6-2.5L (4GR-FSE) (2007)
/Page-2146010.png)
HINT: If an area other than that specified is coated by accident, wipe off the primer with a clean piece of cloth before it dries.
e. Apply adhesive (Adhesive: Part No. 08850-00801 or equivalent).
1. Cut off the tip of the cartridge nozzle, as shown in the illustration.
HINT: After cutting off the tip, use all adhesive within the time described in the table below.
2. Load the sealer gun with the cartridge.
3. Coat the glass with adhesive, as shown in the illustration.
f.
Install the glass.
1. Using a suction cup, position the glass so that the reference marks are aligned, and press it in gently along the rim.
NOTICE:
-
Allow the primer coating to dry for 3 minutes or more.
-
Check that the stoppers are attached to the vehicle body correctly.
-
Check the clearance between the vehicle body and glass.
