IS 250C V6-2.5L (4GR-FSE) (2011)
HINT
The illustration is for the LH side. The RH side is the opposite of the LH side.
(b) Disconnect the sensor connector.
(c) Disengage the 2 claws and remove the No. 1 ultrasonic sensor.
HINT
The illustration is for the LH side. The RH side is the opposite of the LH side.
(d) Using a screwdriver with its tip wrapped with protective tape, disengage the claw and remove the ultrasonic sensor clip as shown in the
illustration.
Text in Illustration
3. REMOVE NO. 3 ULTRASONIC SENSOR RETAINER (for Corner Sensor)
(a) Disengage the 4 claws and remove the No. 3 ultrasonic sensor retainer from the rear bumper assembly.