lexus Workshop Repair Guides

Lexus Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 5220 > < Initial Inspection and Diagnostic Overview|Page 5218
Page 19
background image

CELLULAR COMMUNICATION: SAFETY CONNECT SYSTEM: DATA LIST / ACTIVE TEST

1. DATA LIST

HINT
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read
without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be
discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save
diagnostic time.

NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values
when deciding whether a part is faulty or not.

(a) Connect the Techstream to the DLC3.

(b) Turn the engine switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Telematics / Data List.

(e) According to the display on the Techstream, read the "Data List".

Telematics (DCM (Telematics Transceiver))

DCM Activation

CELLULAR COMMUNICATION: SAFETY CONNECT SYSTEM: DCM ACTIVATION

1. DCM ACTIVATION

This function should be used to activate the DCM (Telematics Transceiver) after a new DCM (Telematics Transceiver) has been installed. During
the DCM Activation process, Techstream automatically provides the telematics service provider with the new DCM (Telematics Transceiver)
information and deletes the old DCM (Telematics Transceiver) information associated with the vehicle. The DCM (Telematics Transceiver) that
was replaced should be returned to the parts department.

(a) Connect the Techstream to the DLC3.

(b) Turn the engine switch on (IG).

(c) Press SOS button 1 time to confirm Service part is currently defective ("Safety Connect is not initialized." voice prompt should be heard).

(d) Turn the Techstream on.

(e) Choose "Telematics" from the System Selection Menu, and then click "Utility".

(f) Click "DCM Service" on the Utility Selection Menu.

(g) Choose "Activate DCM" and then click "Next" on the DCM Service Utility.

Initial Inspection and Diagnostic Overview|Page 5220 > < Initial Inspection and Diagnostic Overview|Page 5218