IS 250C V6-2.5L (4GR-FSE) (2011)
Steering Mounted Controls Transmitter: Service and Repair
Installation
STEERING COLUMN: STEERING PAD SWITCH: INSTALLATION
1. INSTALL STEERING PAD SWITCH ASSEMBLY
(a) Engage the 2 pins to install the steering pad switch.
(b) Install the screw.
Torque : 2.4 Nm (25 kgf-cm, 21 in-lbf)
(c) Engage the 2 pins to install the steering pad switch.
(d) Install the screw.
Torque : 2.4 Nm (25 kgf-cm, 21 in-lbf)
(e) Connect the steering pad switch connector to the spiral cable.
(f) Connect the cruise control main switch connector and install the connector clamp.
2. INSTALL STEERING PAD See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Removal and Replacement/Steering
Pad/Installation
3. INSTALL LOWER NO. 3 STEERING WHEEL COVER See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Removal and
Replacement/Steering Pad/Installation
4. INSTALL LOWER NO. 2 STEERING WHEEL COVER See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Removal and
Replacement/Steering Pad/Installation
5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
6. INSPECT SRS WARNING LIGHT