IS 250C V6-2.5L (4GR-FSE) (2011)
Text in Illustration
23. REMOVE REAR BUMPER PLATE RH
HINT
Use the same procedure for the RH side and LH side.
24. REMOVE REAR BUMPER ASSEMBLY
(a) w/ Intuitive Parking Assist System:
(1) Disconnect the No. 3 luggage room wire connector.
(b) Put protective tape around the rear bumper assembly.
Text in Illustration
(c) Using a clip remover, remove the 4 clips.
(d) Remove the 2 screws.
(e) Remove the 4 screws and 2 rear bumper seal brackets.
(f) Disengage the 6 claws and disconnect the rear bumper assembly as shown in the illustration.
HINT