IS 250C V6-2.5L (4GR-FSE) (2011)
/Page-2020006.png)
*
In order to prevent the rear differential carrier and rear drive shaft assemblies from tilting excessively or falling, perform the
following procedure using several people to hold the rear differential carrier and rear drive shaft assemblies.
NOTICE:
*
Keep the jack, rear differential carrier and rear drive shaft assemblies level.
*
Do not damage the installation surface when installing the rear differential carrier assembly.
(c) Using a straight hexagon and a wrench, temporarily install the rear differential carrier assembly to the suspension member assembly with 3 new
bolts (A) as shown in the illustration.
(d) Temporarily install the rear differential carrier assembly to the suspension member sub-assembly with 2 new bolts (B) and 2 rear lower
differential mount stoppers.
NOTICE:
Make sure not to install the rear lower differential mount stoppers upside down.
(e) Using 2 straight hexagons, a wrench and torque wrench, fully tighten the 3 bolts (A) as shown in the illustration.
Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)
NOTICE:
*
Tighten the 2 bolts (A) on the left side of the vehicle first.
*
Use the formula to calculate special torque values for situations where the wrench is combined with a torque wrench See:
Service Precautions.
(f) Fully tighten the 2 bolts (B).
Torque : 95 Nm (970 kgf-cm, 70 ft-lbf)
NOTICE:
*
Make sure to tighten the bolts after checking that the rear upper differential mount stopper and rear lower differential mount
stopper are not misaligned or inclined.
*
Do not tilt the inner sleeve or distort rubber parts when fully tightening the bolts (B).
16. INSTALL REAR DIFFERENTIAL CARRIER ASSEMBLY (for 4GR-FSE)
NOTICE:
When temporarily installing the rear differential carrier assembly and fully tightening its bolts, do not misalign the rear differential
mount cushion bolt holes or rear differential carrier assembly bolts.
(a) Install the 2 rear upper differential mount stoppers to the rear differential carrier assembly.
NOTICE:
