IS 250C V6-2.5L (4GR-FSE) (2011)
Text in Illustration
NOTICE:
*
Make sure that the actuator connector can be connected smoothly. Do not allow water, oil or dirt to enter.
*
Make sure that the connector is locked securely.
4. INSTALL BRAKE MASTER CYLINDER SUB-ASSEMBLY
HINT
Refer to the instructions for Installation of the brake master cylinder sub-assembly See: Hydraulic System/Brake Master
Cylinder/Service and Repair/Removal and Replacement/Installation.
5. PERFORM YAW RATE AND ACCELERATION SENSOR ZERO POINT CALIBRATION
HINT
See: Testing and Inspection/Programming and Relearning
6. INSPECT SENSOR SIGNAL
HINT
See: Testing and Inspection/Scan Tool Testing and Procedures/Test Mode Procedure
7. INSPECT ACTUATOR USING TECHSTREAM
HINT
See: Testing and Inspection