IS 250C V6-2.5L (4GR-FSE) (2011)
(b) Connect the brake master cylinder push rod clevis to the brake pedal support assembly with the push rod pin and a new clip.
7. INSTALL BRAKE PEDAL RETURN SPRING
(a) Install the brake pedal return spring.
8. INSTALL BRAKE ACTUATOR ASSEMBLY WITH BRACKET See: Antilock Brakes / Traction Control Systems/Hydraulic Control
Assembly - Antilock Brakes/Service and Repair/Installation
9. INSTALL BRAKE MASTER CYLINDER SUB-ASSEMBLY See: Hydraulic System/Brake Master Cylinder/Service and Repair/Removal and
Replacement/Installation
10. CONNECT CLUTCH RESERVOIR HOSE (for Manual Transmission) See: Hydraulic System/Brake Master Cylinder/Service and
Repair/Removal and Replacement/Installation
11. INSTALL NO. 3 ENGINE ROOM RELAY BLOCK See: Hydraulic System/Brake Master Cylinder/Service and Repair/Removal and
Replacement/Installation
12. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY
HINT
Refer to the procedure from Install Driver Side Knee Airbag Assembly See: Restraint Systems/Air Bag Systems/Air Bag/Service and
Repair/Removal and Replacement/Knee Airbag Assembly (for Driver Side)/Installation.
13. BLEED BRAKE SYSTEM
HINT
See: Brake Bleeding/Service and Repair
14. BLEED CLUTCH LINE (for Manual Transmission)
HINT
See: Transmission and Drivetrain/Clutch/Service and Repair/Procedures
15. INSPECT AND ADJUST BRAKE PEDAL
HINT
See: Brake Pedal Assy/Adjustments
16. INSTALL FRONT WHEEL
Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)
17. INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY
HINT
Refer to the procedure from Install Cowl Top Ventilator Louver Sub-assembly See: Wiper and Washer Systems/Wiper
Motor/Service and Repair/Installation.