IS 250C V6-2.5L (4GR-FSE) (2011)
Crankshaft Main Bearing Seal: Service and Repair
Installation
4GR-FSE ENGINE MECHANICAL: REAR CRANKSHAFT OIL SEAL: INSTALLATION
1. INSTALL REAR ENGINE OIL SEAL
(a) Apply MP grease to the lip of a new oil seal.
NOTICE:
Keep the lip free of foreign matter.
(b) Using SST and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.
SST : 09223-15030
SST : 09950-70010
09951-07150
Oil seal tap in depth:
0 to 1.0 mm (0 to 0.0394 in.)
NOTICE:
*
Wipe extra grease off the crankshaft.
*
Keep the lip free of foreign matter.
*
Do not tap on the oil seal at an angle.
2. INSTALL FLYWHEEL SUB-ASSEMBLY (for Manual Transmission)
(a) Using SST, hold the crankshaft pulley.
SST : 09213-70011
09213-70020
SST : 09330-00021
(b) Using several steps, install and tighten 8 new bolts uniformly in the sequence shown in the illustration.