IS 250C V6-2.5L (4GR-FSE) (2011)
12. REMOVE CAMSHAFT HOUSING SUB-ASSEMBLY RH
(a) Remove the camshaft housing sub-assembly RH by prying between the cylinder head and camshaft housing sub-assembly RH with a
screwdriver.
Text in Illustration
NOTICE:
Be careful not to damage the contact surfaces of the cylinder head and camshaft housing sub-assembly RH.
HINT
Tape the screwdriver tip before use.
13. REMOVE CAMSHAFT TIMING GEARS AND NO. 2 CHAIN (for Bank 2)
(a) While pushing down the No. 3 chain tensioner assembly, insert a pin of 1.0 mm (0.0394 in.) diameter into the hole to hold the No. 3 chain
tensioner assembly.
Text in Illustration
(b) Using SST to hold the hexagonal portion of each camshaft, loosen the flange bolts of the camshaft timing gear assembly and the camshaft
timing exhaust gear assembly LH.
SST : 09922-10010
Text in Illustration
NOTICE:
*
Be careful not to damage the cylinder head with SST.