IS 250C V6-2.5L (4GR-FSE) (2011)
Installation
HEATING / AIR CONDITIONING: COMPRESSOR (for 4GR-FSE): INSTALLATION
1. INSTALL COMPRESSOR AND MAGNETIC CLUTCH
(a) Using a "TORX" socket wrench (E8), temporarily install the compressor and magnetic clutch with the stud bolt.
Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)
(b) Install the compressor and magnetic clutch with the 3 bolts and nut.
Torque : 25 Nm (255 kgf-cm, 18 ft-lbf)
NOTICE:
Tighten the bolts in the order shown in the illustration to install the compressor and magnetic clutch.
2. INSTALL NO. 1 COOLER REFRIGERANT SUCTION HOSE
(a) Remove the attached vinyl tape from the hose.
(b) Apply sufficient compressor oil to a new O-ring and the fitting surface of the compressor and magnetic clutch.
Compressor oil:
ND-OIL 8 or equivalent
(c) Install the O-ring onto the No. 1 cooler refrigerant suction hose.
NOTICE:
Keep the O-ring and O-ring fitting surfaces free from dirt or any foreign objects.
(d) Install the No. 1 cooler refrigerant suction hose onto the compressor and magnetic clutch with the bolt.
Torque : 9.8 Nm (100 kgf-cm, 87 in-lbf)
3. INSTALL DISCHARGE HOSE SUB-ASSEMBLY
(a) Remove the attached vinyl tape from the hose.