IS 250C V6-2.5L (4GR-FSE) (2011)
Refrigerant Pressure Sensor / Switch: Service and Repair
Installation
HEATING / AIR CONDITIONING: AIR CONDITIONING PRESSURE SENSOR: INSTALLATION
1. INSTALL NO. 1 AIR CONDITIONING PRESSURE SENSOR
(a) Sufficiently apply compressor oil to a new No. 1 air conditioning pressure sensor.
Compressor oil:
ND-OIL 8 or equivalent
(b) Install the new air conditioning pressure sensor.
Torque : 11 Nm (112 kgf-cm, 8 ft-lbf)
(c) Connect the connector.
2. INSTALL NO. 2 AIR CONDITIONING PRESSURE SENSOR (w/ No. 2 Air Conditioning Pressure Sensor)
(a) Sufficiently apply compressor oil to a new No. 2 air conditioning pressure sensor.
Compressor oil:
ND-OIL 8 or equivalent
(b) Install the new air conditioning pressure sensor.
Torque : 14 Nm (143 kgf-cm, 10 ft-lbf)
(c) Connect the connector.
3. CHARGE WITH REFRIGERANT See: Service and Repair
4. WARM UP ENGINE See: Service and Repair
5. INSPECT FOR REFRIGERANT LEAK See: Service and Repair
6. INSTALL ENGINE ROOM SIDE COVER LH (w/ No. 2 Air Conditioning Pressure Sensor) See: Wiper and Washer Systems/Wiper
Motor/Service and Repair/Installation
7. INSTALL FRONT BUMPER ASSEMBLY
HINT
Refer to the procedure from Install Front Bumper Assembly See: Body and Frame/Bumper/Front Bumper/Service and
Repair/Removal and Replacement/Installation.