IS 250C V6-2.5L (4GR-FSE) (2011)
Fuel Gauge Sender: Service and Repair
Removal
4GR-FSE FUEL: FUEL SENDER GAUGE ASSEMBLY: REMOVAL
1. REMOVE FUEL SUCTION TUBE ASSEMBLY WITH PUMP AND GAUGE
(a) Remove the fuel suction tube assembly with pump and gauge See: Powertrain Management/Fuel Delivery and Air Induction/Fuel
Pump/Service and Repair/Removal and Replacement/Fuel Pump/Removal.
2. REMOVE FUEL SENDER GAUGE
(a) Disconnect the fuel sender gauge connector.
(b) Press down on the sender gauge claw labeled A. Then slide the sender gauge upward.
3. REMOVE REAR SEAT CUSHION ASSEMBLY RH See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Rear Seat
Assembly/Removal
4. REMOVE REAR FLOOR SERVICE HOLE COVER
(a) Remove the rear floor service hole cover.
5. REMOVE FUEL SENDER GAUGE ASSEMBLY
(a) Disconnect the fuel sender gauge connector.
(b) Remove the 5 bolts and fuel sender gauge.
(c) Remove the fuel sender gauge from the fuel tank.
NOTICE:
Be careful not to bend the arm of the fuel sender gauge.