IS 250C V6-2.5L (4GR-FSE) (2011)
(b) Disconnect the connector and remove the front tire pressure antenna RH.
Installation
TIRE PRESSURE MONITORING: TIRE PRESSURE WARNING ANTENNA (for Front Side): INSTALLATION
1. INSTALL FRONT TIRE PRESSURE ANTENNA RH
(a) Connect the connector.
(b) Install the front tire pressure antenna RH with the nut.
Torque : 7.5 Nm (76 kgf-cm, 66 in-lbf)
HINT
Engage the tab into the hole as shown in the illustration to install the front tire pressure antenna RH.
2. INSTALL FRONT FENDER LINER RH
HINT
Perform the same procedure as for the LH side See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Keyless
Entry/Service and Repair/Installation.
3. INSTALL FRONT WHEEL OPENING EXTENSION PAD RH
HINT
Perform the same procedure as for the LH side See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Keyless
Entry/Service and Repair/Installation.
4. INSTALL FRONT WHEEL RH
Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)
5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
6. INSPECT TIRE PRESSURE WARNING SYSTEM
(a) Inspect the tire pressure warning system See: Testing and Inspection/Scan Tool Testing and Procedures/Test Mode Procedure.