IS 250C V6-2.5L (4GR-FSE) (2011)
Secondary Injector Control Module: Service and Repair
Removal
4GR-FSE FUEL: INJECTOR DRIVER: REMOVAL
1. REMOVE COOL AIR INTAKE DUCT SEAL See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine
Assembly/Removal
2. REMOVE NO. 1 INLET AIR CLEANER See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine
Assembly/Removal
3. REMOVE NO. 1 ENGINE COVER See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine
Unit/Removal
4. REMOVE INJECTOR DRIVER
(a) Disconnect the 4 connectors from the injector driver.
(b) Remove the bolt, 2 nuts and injector driver.
NOTICE:
Be careful not to drop or strike the injector driver.