IS 250C V6-2.5L (4GR-FSE) (2011)
SST : 09224-00010
without SST - Torque : 44 Nm (449 kgf-cm, 32 ft-lbf)
with SST - Torque : 40 Nm (408 kgf-cm, 30 ft-lbf)
NOTICE:
*
The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).
*
The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 300 mm (11.81 in.).
*
This torque value is effective when SST is parallel to the torque wrench.
(b) Connect the 2 clamps and air fuel ratio sensor connector (for Bank 1 Sensor 1).
5. INSTALL NO. 4 ENGINE WIRE
(a) Connect the connector and install the 2 clamps.
(b) Connect the No. 1 engine wire to the engine room No. 1 junction block. Then, install it with the nut.
Torque : 12 Nm (124 kgf-cm, 9 ft-lbf)
(c) Install the engine room No. 1 relay block cover.
6. INSTALL BATTERY TRAY
(a) Install the battery tray with the 3 bolts.