IS 250C V6-2.5L (4GR-FSE) (2011)
Central Control Module: Service and Repair
Installation
NETWORKING: NETWORK GATEWAY ECU: INSTALLATION
1. INSTALL NETWORK GATEWAY ECU
(a) Install the network gateway ECU.
(b) Engage the 2 claws to install the cover.
(c) Connect the connector.
2. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument
Panel/Service and Repair/Removal and Replacement/Installation
3. INSTALL FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY See: Restraint Systems/Air Bag Systems/Air Bag/Service and
Repair/Removal and Replacement/Knee Airbag Assembly (for Front Passenger Side)/Installation
4. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard /
Instrument Panel/Service and Repair/Removal and Replacement/Installation
5. INSTALL SIDE INSTRUMENT PANEL See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Removal and Replacement/Installation
6. INSTALL FRONT DOOR OPENING TRIM COVER
7. INSTALL FRONT DOOR SCUFF PLATE
8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system See: Restraint
Systems/Air Bag Systems/Service Precautions.
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and Inspection/Repair
Instruction - Initialization.
9. INSPECT SRS WARNING LIGHT
See: Restraint Systems/Air Bag Systems/Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnosis System