IS 250C V6-2.5L (4GR-FSE) (2011)
Clockspring Assembly / Spiral Cable: Service and Repair
Installation
SUPPLEMENTAL RESTRAINT SYSTEMS: SPIRAL CABLE: INSTALLATION
1. INSTALL SPIRAL CABLE
(a) Engage the 6 claws and 2 pins to install the spiral cable to the steering angle sensor.
2. INSTALL SPIRAL CABLE WITH STEERING ANGLE SENSOR
(a) Check that the engine switch is off.
(b) Check that the cable is disconnected from the negative (-) battery terminal.
(c) Set the turn signal switch to the neutral position.
NOTICE:
If it is not in the neutral position, the turn signal switch pin may snap.
(d) Engage the 3 claws to install the spiral cable with steering angle sensor.
NOTICE:
When replacing the spiral cable with a new one, remove the lock pin before installing the steering wheel assembly.
(e) Connect the connectors to the spiral cable with steering angle sensor.
NOTICE:
When connecting any airbag connector, take care not to damage the airbag wire harness.
3. INSTALL STEERING COLUMN COVER (for Upper Side) See: Steering and Suspension/Steering/Steering Column/Service and
Repair/Removal and Replacement/Installation
4. INSTALL STEERING COLUMN COVER (for Lower Side) See: Steering and Suspension/Steering/Steering Column/Service and
Repair/Removal and Replacement/Installation