IS 250C V6-2.5L (4GR-FSE) (2011)
CAUTION:
If the LED is illuminated when the deployment switch is not pressed, SST may be malfunctioning. In this case, do not use the
malfunctioning SST.
(b) Connect SST.
(1) Connect 2 SST, and then connect them to the front seat outer belt pretensioner.
SST : 09082-00700
SST : 09082-00770
NOTICE:
To avoid damaging the SST connector and wire harness, do not lock the secondary lock of the pretensioner connector.
(2) Place the outer belt on the ground and cover it with a tire and wheel assembly.
NOTICE:
Position the front seat outer belt assembly as shown in the illustration.
(3) Position and hold SST at least 10 m (33 ft.) away from the wheel.
NOTICE:
Do not damage the SST wire harness.
(c) Deploy the front seat outer belt pretensioner.
(1) Check that no one is within a 10 m (33 ft.) radius of the wheel.
(2) Connect the red clip of SST to a battery positive (+) terminal and the black clip to a battery negative (-) terminal.
(3) Press the SST deployment switch to deploy the front seat outer belt pretensioner.
HINT