IS 250C V6-2.5L (4GR-FSE) (2011)
When connected, the outer connector locking sleeve will slide. Be sure not to hold the outer connector locking sleeve while connecting,
as it may result in an insecure fit.
(e) Check that there is no looseness in the installation parts of the side airbag sensor.
2. INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY
for LH Side: See: Seat Belt Systems/Seat Belt/Service and Repair/Removal and Replacement/Front Seat Outer Belt Assembly/Installation
for RH Side: See: Seat Belt Systems/Seat Belt/Service and Repair/Removal and Replacement/Front Seat Outer Belt Assembly/Installation
3. CONNECT FRONT SEAT OUTER BELT ASSEMBLY
for LH Side: See: Seat Belt Systems/Seat Belt/Service and Repair/Removal and Replacement/Front Seat Outer Belt Assembly/Installation
for RH Side: See: Seat Belt Systems/Seat Belt/Service and Repair/Removal and Replacement/Front Seat Outer Belt Assembly/Installation
4. INSTALL LAP BELT OUTER ANCHOR COVER See: Seat Belt Systems/Seat Belt/Service and Repair/Removal and Replacement/Front Seat
Outer Belt Assembly/Installation
5. INSTALL DOOR SCUFF PLATE ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal and
Replacement/Roof Headlining (for Front Side)/Installation
6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
7. INSTALL REAR SEATBACK ASSEMBLY WITH CONSOLE BOX
HINT
Refer to the procedure from Install Rear Seatback Assembly with Console Box See: Body and Frame/Seats/Service and
Repair/Removal and Replacement/Rear Seat Assembly/Installation.
8. PERFORM DIAGNOSTIC SYSTEM CHECK
(a) Perform a diagnostic system check See: Air Bag Systems/Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes.
9. INSPECT SRS WARNING LIGHT
(a) Inspect the SRS warning light See: Air Bag Systems/Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnosis System.