IS 250C V6-2.5L (4GR-FSE) (2011)
HINT
When engaged, the white housing lock will slide. Be sure not to hold the white housing lock and part (A), as it may result in an
insecure fit.
(f) Check that there is no looseness in the installation parts of the front airbag sensor.
2. INSTALL HEADLIGHT ASSEMBLY See: Lighting and Horns/Headlamp/Service and Repair/Removal and Replacement/Installation
3. INSTALL FRONT UPPER FENDER PROTECTOR LH (for LH Side) See: Wiper and Washer Systems/Wiper Motor/Service and
Repair/Installation
4. INSTALL ENGINE ROOM SIDE COVER LH (for LH Side)
for 4GR-FSE: See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine Assembly/Installation
for 2GR-FSE: See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine Assembly/Installation
5. INSTALL FRONT UPPER FENDER PROTECTOR RH (for RH Side)
HINT
Use the same procedure for the RH side and LH side See: Wiper and Washer Systems/Wiper Motor/Service and Repair/Installation.
6. INSTALL ENGINE ROOM SIDE COVER RH (for RH Side)
for 4GR-FSE: See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine Assembly/Installation
for 2GR-FSE: See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine Assembly/Installation
7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
8. INSTALL FRONT BUMPER ASSEMBLY
HINT
Refer to the procedure from Install Front Bumper Assembly See: Body and Frame/Bumper/Front Bumper/Service and
Repair/Removal and Replacement/Installation.
9. INSPECT AND ADJUST HEADLIGHT AIMING
(a) Inspect and adjust headlight aiming See: Lighting and Horns/Headlamp/Adjustments.
10. PERFORM DIAGNOSTIC SYSTEM CHECK
(a) Perform a diagnostic system check See: Restraint Systems/Air Bag Systems/Testing and Inspection/Reading and Clearing Diagnostic
Trouble Codes.
11. INSPECT SRS WARNING LIGHT
(a) Inspect the SRS warning light See: Restraint Systems/Air Bag Systems/Testing and Inspection/Initial Inspection and Diagnostic
Overview/Diagnosis System.