IS 250C V6-2.5L (4GR-FSE) (2011)
Text in Illustration
(b) Install the armature assembly to the starter commutator end frame assembly.
(c) Apply high-temperature grease to the armature shaft.
(d) Install the plate washer to the armature shaft.
NOTICE:
Do not damage starter commutator end frame.
(e) Using snap ring pliers, install the snap ring.
Text in Illustration
NOTICE:
*
Be sure to install the snap ring in the armature shaft groove securely.
*
Be sure to properly install the snap ring because it easily expands.
(f) Using a vernier caliper, measure the snap ring.
Text in Illustration
Maximum length:
5.0 mm (0.197 in.)
If the length is greater than the maximum, replace the snap ring.