IS 250C V6-2.5L (4GR-FSE) (2011)
2. INSPECT STARTER RELAY
(a) Remove the STARTER relay from the engine room relay block No. 1.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
(c) Reinstall the STARTER relay.
NG -- REPLACE STARTER RELAY
OK -- Continue to next step.
3. CHECK HARNESS AND CONNECTOR (STARTER RELAY - BODY GROUND)
(a) Remove the STARTER relay from the engine room relay block No. 1.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance (Check for Open):
(c) Reinstall the STARTER relay.
Result:
C -- REPAIR OR REPLACE HARNESS OR CONNECTOR
B -- CHECK HARNESS AND CONNECTOR (CLUTCH PEDAL SWITCH - STARTER RELAY)
A -- Continue to next step.
4. CHECK HARNESS AND CONNECTOR (PARK/NEUTRAL POSITION SWITCH - STARTER RELAY)
(a) Disconnect the park/neutral position switch connector.
(b) Remove the STARTER relay from the engine room relay block No. 1.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance (Check for Open):