IS 250C V6-2.5L (4GR-FSE) (2011)
Text in Illustration
(b) Remove the center wheel ornament.
(c) Install a camber-caster-kingpin gauge at the center of the axle hub or drive shaft.
(d) Inspect the camber, caster, and steering axis inclination.
Camber (Unloaded Vehicle):
Caster (Unloaded Vehicle):
Steering Axis (Unloaded Vehicle):
NOTICE:
Inspect while the vehicle is unloaded.
If the camber and steering axis inclination are not within the specified range after the caster has been correctly adjusted, recheck the suspension
parts for damaged and/or worn out parts.
(e) Remove the camber-caster-kingpin gauge.
(f) Install the center wheel ornament.
4. ADJUST CASTER
(a) According to the caster measurement, select a lower arm bracket sub-assembly.
Text in Illustration
HINT
Refer to the instructions for Removal and Installation of the front lower suspension arm See: Suspension/Control Arm/Service and
Repair/Front Lower Suspension Arm/Removal.