IS 250C V6-2.5L (4GR-FSE) (2011)
Wheel Turning Angle (Unloaded Vehicle):
NOTICE:
Inspect while the vehicle is unloaded.
If the right and left inside wheel angles differ from the specified range, check the lengths of the right and left rack ends.
8. INSPECT FRONT SUSPENSION
(a) Inspect the front suspension member.
(1) Measure the dimension between the center of the 2 installation bolts of the front lower suspension arm.
Standard:
692.5 to 699.5 mm (2.27 to 2.30 ft.)
If the result is not within the specification, replace the front suspension member.
HINT
Refer to the instructions for Removal and Installation of the front suspension member See: Suspension/Cross-Member/Front
Cross-Member/Service and Repair/Removal.
(b) Inspect the front lower suspension arm assembly.
(1) Remove the front lower suspension arm assembly.
HINT
Refer to the instructions for Removal of the front lower suspension arm See: Suspension/Control Arm/Service and Repair/Front
Lower Suspension Arm/Removal.
(2) Measure the dimension between the center of the front lower suspension arm assembly bush and the center of position A.
Standard:
362 to 364.6 mm (1.19 to 1.20 ft.)