IS 250C V6-2.5L (4GR-FSE) (2011)
Torque : 70 Nm (714 kgf-cm, 52 ft-lbf)
3. TEMPORARILY TIGHTEN REAR NO. 2 SUSPENSION ARM ASSEMBLY
(a) Temporarily install the stabilizer link assembly and height control sensor link bracket to the rear No. 2 suspension arm assembly with the bolt
and nut.
Text in Illustration
HINT
There is only the height control sensor link bracket on vehicles with the HID headlight system.
(b) Temporarily install the rear shock absorber with coil spring with the bolt and nut.
NOTICE:
Turn the bolt while holding the nut.
4. STABILIZE SUSPENSION See: Suspension Strut / Shock Absorber/Service and Repair/Rear Shock Absorber/Installation
5. FULLY TIGHTEN REAR NO. 1 UPPER CONTROL ARM ASSEMBLY
(a) Fully tighten the nut.
Torque : 161 Nm (1642 kgf-cm, 119 ft-lbf)
NOTICE:
The final torque must be applied under standard vehicle height conditions.
(b) Using a ball joint lock nut wrench, fully tighten the nut.