IS 250C V6-2.5L (4GR-FSE) (2011)
4. REMOVE CONSOLE PANEL SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Removal and Replacement/Removal
5. REMOVE FRONT ASH RECEPTACLE ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service
and Repair/Removal and Replacement/Removal
6. REMOVE REAR ASH RECEPTACLE ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Removal and
Replacement/Front Console Box/Removal
7. REMOVE CONSOLE BOX REGISTER ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Removal and
Replacement/Front Console Box/Removal
8. REMOVE CONSOLE BOX See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Removal and Replacement/Front
Console Box/Removal
9. REMOVE NO. 2 CONSOLE BOX DUCT See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Removal and Replacement/Removal
10. REMOVE FRONT EXHAUST PIPE ASSEMBLY
See: Engine, Cooling and Exhaust/Exhaust System/Exhaust Pipe/Service and Repair/Removal
11. REMOVE FRONT NO. 1 FLOOR HEAT INSULATOR See: Drive/Propeller Shafts, Bearings and Joints/Drive/Propeller Shaft/Service and
Repair/Removal and Replacement/Removal
12. SEPARATE FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY
(a) Remove the nut and separate the floor shift gear shifting rod sub-assembly.
13. REMOVE TRANSMISSION FLOOR SHIFT ASSEMBLY
(a) Disconnect the 2 connectors and 4 clamps.
(b) Remove the 4 bolts.
(c) Remove the floor shift assembly.
Installation
A960E AUTOMATIC TRANSMISSION / TRANSAXLE: SHIFT LEVER: INSTALLATION
1. INSTALL TRANSMISSION FLOOR SHIFT ASSEMBLY
(a) Install the floor shift assembly with the 4 bolts.