IS 250C V6-2.5L (4GR-FSE) (2011)
3. REMOVE NO. 1 BODY MOUNTING BRACKET SUB-ASSEMBLY LH See: Engine, Cooling and Exhaust/Engine/Service and
Repair/Removal and Replacement/Engine Assembly/Removal
4. REMOVE NO. 1 BODY MOUNTING BRACKET SUB-ASSEMBLY RH See: Engine, Cooling and Exhaust/Engine/Service and
Repair/Removal and Replacement/Engine Assembly/Removal
5. REMOVE NO. 2 ENGINE UNDER COVER See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine
Assembly/Removal
6. DRAIN AUTOMATIC TRANSMISSION FLUID
(a) Remove the drain plug and gasket, and drain the ATF.
(b) Install a new gasket and the drain plug.
Torque : 20 Nm (204 kgf-cm, 15 ft-lbf)
7. REMOVE NO. 1 EXHAUST PIPE SUPPORT BRACKET SUB-ASSEMBLY
(a) Remove the 4 bolts, 2 nuts and No. 1 exhaust pipe support bracket sub-assembly.
8. REMOVE AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY
NOTICE:
Some fluid will remain in the oil pan.
(a) Remove the 20 bolts, oil pan and gasket.
(b) Remove the 3 magnets from the oil pan.
Text in Illustration
(c) Examine particles in the pan.