IS 250C V6-2.5L (4GR-FSE) (2011)
Clutch Master Cylinder: Service and Repair
Removal
CLUTCH: CLUTCH MASTER CYLINDER: REMOVAL
1. PRECAUTION (w/ Navigation System for HDD)
NOTICE:
After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of
memory and settings. As a result, after turning the engine switch off, make sure to wait at least 60 seconds before disconnecting the
cable from the negative (-) battery terminal.
2. PRECAUTION
See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service Precautions
3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
4. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY
See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Removal and Replacement/Knee Airbag Assembly (for Driver
Side)/Removal
5. DISCONNECT WIRE HARNESS
(a) Disconnect the 3 connectors and clamp.
6. DISCONNECT CLUTCH RESERVOIR TUBE See: Clutch Pedal Assembly/Service and Repair/Removal
7. DISCONNECT CLUTCH LINE
(a) Using a union nut wrench (10 mm), disconnect the clutch line from the clutch master cylinder.
HINT
Use a container to catch the fluid.
8. REMOVE CLUTCH PEDAL SUPPORT SUB-ASSEMBLY See: Clutch Pedal Assembly/Service and Repair/Removal
9. REMOVE CLUTCH PEDAL SWITCH ASSEMBLY
(a) Remove the nut and clutch pedal switch assembly from the clutch pedal support.
10. REMOVE CLUTCH MASTER CYLINDER PUSH ROD CLEVIS PIN
(a) Remove the clip and pin.