IS 250C V6-2.5L (4GR-FSE) (2011)
(a) Remove the 2 bolts and clutch release cylinder.
Installation
CLUTCH: CLUTCH RELEASE CYLINDER: INSTALLATION
1. TEMPORARILY TIGHTEN CLUTCH RELEASE CYLINDER ASSEMBLY
(a) Temporarily tighten the clutch release cylinder with the 2 bolts.
2. TEMPORARILY TIGHTEN CLUTCH ACCUMULATOR ASSEMBLY
(a) Temporarily tighten the clutch accumulator with the 3 bolts.
3. CONNECT CLUTCH LINE
(a) Using a union nut wrench (10 mm), connect the clutch line.
Torque : 15 Nm (155 kgf-cm, 11 ft-lbf)
CAUTION:
Use the formula to calculate special torque values for situations where the union nut wrench is combined with a torque wrench See:
Service Precautions.
4. FULLY TIGHTEN CLUTCH RELEASE CYLINDER ASSEMBLY
(a) Fully tighten the clutch release cylinder with the 2 bolts.