IS 250C V6-2.5L (4GR-FSE) (2011)
Perform the same procedure as the LH side.
30. REMOVE REAR NO. 2 UPPER CONTROL ARM ASSEMBLY (for LH Side) See: Steering and Suspension/Suspension/Control Arm/Service
and Repair/Rear Upper Arm/Removal
31. REMOVE REAR NO. 2 UPPER CONTROL ARM ASSEMBLY (for RH Side)
HINT
Perform the same procedure as the LH side.
32. SEPARATE REAR NO. 1 UPPER CONTROL ARM ASSEMBLY (for LH Side) See: Drive Axles, Bearings and Joints/Wheel Hub/Service and
Repair/Rear Axle Hub/Removal
33. SEPARATE REAR NO. 1 UPPER CONTROL ARM ASSEMBLY (for RH Side)
HINT
Perform the same procedure as the LH side.
34. SEPARATE REAR NO. 2 SUSPENSION ARM ASSEMBLY LH See: Drive Axles, Bearings and Joints/Wheel Hub/Service and Repair/Rear
Axle Hub/Removal
35. SEPARATE REAR NO. 2 SUSPENSION ARM ASSEMBLY RH
HINT
Perform the same procedure as the LH side.
36. REMOVE REAR AXLE ASSEMBLY LH See: Drive Axles, Bearings and Joints/Wheel Hub/Service and Repair/Rear Axle Hub/Removal
37. REMOVE REAR AXLE ASSEMBLY RH
HINT
Perform the same procedure as the LH side.
38. REMOVE REAR DRIVE SHAFT ASSEMBLY LH See: Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and Repair/Removal
39. REMOVE REAR DRIVE SHAFT ASSEMBLY RH
HINT
Perform the same procedure as the LH side.
40. REMOVE HOLE SNAP RING LH See: Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and Repair/Removal
41. REMOVE HOLE SNAP RING RH
HINT
Perform the same procedure as the LH side.
42. REMOVE REAR LOWER SUSPENSION MEMBER STOPPER REINFORCE LH See: Steering and Suspension/Suspension/Stabilizer
Bar/Service and Repair/Rear Stabilizer Bar/Removal
43. REMOVE REAR LOWER SUSPENSION MEMBER STOPPER REINFORCE RH
HINT
Perform the same procedure as the LH side.
44. REMOVE REAR STABILIZER BAR See: Steering and Suspension/Suspension/Stabilizer Bar/Service and Repair/Rear Stabilizer Bar/Removal
45. REMOVE REAR DIFFERENTIAL CARRIER ASSEMBLY
(a) Support the rear differential carrier assembly with a jack.
CAUTION:
*
The rear differential carrier assembly is very heavy. Make sure to securely support it with a transmission jack to prevent it from
dropping.
*
In order to prevent the rear differential carrier assembly from tilting excessively or falling, perform the following procedure using
several people to hold the rear differential carrier assembly.