IS 250C V6-2.5L (4GR-FSE) (2011)
42. FULLY TIGHTEN REAR NO. 2 UPPER CONTROL ARM ASSEMBLY (for RH Side)
HINT
Perform the same procedure as the LH side.
43. FULLY TIGHTEN REAR NO. 1 SUSPENSION ARM ASSEMBLY LH See: Steering and Suspension/Suspension/Control Arm/Service and
Repair/Rear Lower Arm/Installation
44. FULLY TIGHTEN REAR NO. 1 SUSPENSION ARM ASSEMBLY RH
HINT
Perform the same procedure as the LH side.
45. FULLY TIGHTEN REAR NO. 2 SUSPENSION ARM ASSEMBLY LH See: Drive Axles, Bearings and Joints/Wheel Hub/Service and
Repair/Rear Axle Hub/Installation
46. FULLY TIGHTEN REAR NO. 2 SUSPENSION ARM ASSEMBLY RH
HINT
Perform the same procedure as the LH side.
47. INSTALL TAIL EXHAUST PIPE ASSEMBLY See: Engine, Cooling and Exhaust/Exhaust System/Exhaust Pipe/Service and Repair/Installation
48. INSTALL PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY
HINT
Refer to the instructions for Installation of the propeller shaft assembly See: Drive/Propeller Shafts, Bearings and
Joints/Drive/Propeller Shaft/Service and Repair/Removal and Replacement/Installation.
49. INSTALL REAR SUSPENSION MEMBER BRACE LH See: Steering and Suspension/Suspension/Suspension Strut / Shock Absorber/Service
and Repair/Rear Shock Absorber/Installation
50. INSTALL REAR SUSPENSION MEMBER BRACE RH
HINT
Perform the same procedure as the LH side.
51. INSTALL NO. 2 DIFFERENTIAL SUPPORT PROTECTOR See: Steering and Suspension/Suspension/Suspension Strut / Shock
Absorber/Service and Repair/Rear Shock Absorber/Installation
52. INSTALL NO. 1 DIFFERENTIAL SUPPORT PROTECTOR
HINT
Perform the same procedure as the No. 2 differential support protector.
53. ADJUST PARKING BRAKE
See: Brakes and Traction Control/Parking Brake System/Adjustments.
54. ADD DIFFERENTIAL OIL See: Fluid - Differential/Service and Repair
55. INSTALL REAR WHEELS
Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)
56. INSPECT AND ADJUST REAR WHEEL ALIGNMENT
See: Maintenance/Alignment/Service and Repair/Rear Wheel Alignment.
57. CHECK SPEED SENSOR SIGNAL
See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and Inspection/Scan Tool Testing and Procedures/Test
Mode Procedure.