IS 250C V6-2.5L (4GR-FSE) (2011)
Text in Illustration
NOTICE:
Make sure that the right and left bearing caps are not interchanged.
(e) Tighten both bearing caps with the 4 bolts.
Torque : 85 Nm (870 kgf-cm, 63 ft-lbf)
(f) Using a dial indicator, measure the runout of the differential ring gear.
Maximum runout:
0.07 mm (0.00275 in.)
(g) Remove the 4 bolts and 2 bearing caps.
Text in Illustration
NOTICE:
Do not swap bearing caps, as each cap is only suitable for its original location and installation direction on the carrier it was
manufactured on.
(h) Remove the right and left (back side and teeth side) side rear differential side gear shaft plate washers.
Text in Illustration