IS 250C V6-2.5L (4GR-FSE) (2011)
*
Install the rear differential drive pinion bearing spacer and rear differential carrier oil seal after adjusting the tooth contact
pattern.
(b) Install the rear differential drive pinion oil slinger to the differential drive pinion.
(c) Using SST, install the rear drive pinion companion flange.
Text in Illustration
SST : 09950-30012
09951-03010
09953-03010
09954-03010
09955-03030
09956-03030
NOTICE:
*
Hold the differential drive pinion until the SST is installed.
*
Install the rear drive pinion companion flange so that there is a slight looseness on the differential drive pinion because the rear
differential drive pinion bearing spacer is not yet installed.
*
Apply grease to the threads and tip of the SST center bolt before use.
(d) Coat the threads of a new rear drive pinion nut with hypoid gear oil LSD.
(e) Using SST and a torque wrench, hold the rear drive pinion companion flange and tighten the rear drive pinion nut.
Text in Illustration