IS 250C V6-2.5L (4GR-FSE) (2011)
Oil seal installation depth (A):
-0.5 to 0.5 mm (-0.0197 to 0.0197 in.)
NOTICE:
*
To ensure a proper seal, evenly tap in the rear differential side gear shaft oil seal.
*
When installing the oil seal, tap it in until its surface is flush with the rear differential carrier.
(b) Apply MP grease to the rear differential side gear shaft oil seal lip.
6. INSTALL REAR DRIVE SHAFT ASSEMBLY
HINT
Refer to the procedure for Installation of the rear drive shaft assembly See: Drive Axles, Bearings and Joints/Axle Shaft
Assembly/Service and Repair/Installation.
7. ADD DIFFERENTIAL OIL See: Fluid - Differential/Service and Repair