IS 250C V6-2.5L (4GR-FSE) (2011)
proper one.
(a) Stabilize the propeller shaft and differential.
(1) Turn the propeller shaft several times by hand to stabilize the center support bearing.
(2) Using a jack, raise and lower the differential to stabilize the differential mounting cushion.
NOTICE:
Measure the joint angle when the vehicle is raised using a four-post lift or when using a pit.
(b) Check both No. 2 and No. 3 joint angles.
(1) Using SST, measure the installation angle of the intermediate shaft and propeller shaft.
SST : 09370-50010
HINT
SST should be set directly on the bottom of the shaft.
(2) Using SST, measure the installation angle of the differential.
SST : 09370-50010
Text in Illustration
HINT
Measure the installation angle by placing SST in the positions shown in the illustration.
(3) Calculate the No. 2 joint angle.
No. 2 joint angle:
A - B = -1°09' to -0°09'
A:
Intermediate shaft installation angle
B:
Propeller shaft installation angle
(4) Calculate the No. 3 joint angle.
No. 3 joint angle:
B - C = 1°12' to 2°12'
B:
Propeller shaft installation angle
C: