IS 250C V6-2.5L (4GR-FSE) (2011)
SST : 09330-00021
(d) Put matchmarks on the intermediate shaft and universal joint flange.
Text in Illustration
(e) Using SST, remove the universal joint flange from the intermediate shaft.
Text in Illustration
SST : 09330-00021
SST : 09950-00020
SST : 09950-00030
NOTICE:
Apply grease to the threads and tip of the SST center bolt before use.
(f) Remove the No. 1 center support bearing assembly and 2 center support bearing washers from the intermediate shaft.
Reassembly
DRIVE SHAFT / PROPELLER SHAFT: PROPELLER SHAFT ASSEMBLY (for 4GR-FSE): REASSEMBLY
1. INSTALL NO. 1 CENTER SUPPORT BEARING ASSEMBLY
(a) Set the No. 1 center support bearing assembly and 2 center support bearing washers on the intermediate shaft assembly as shown in the
illustration.
Text in Illustration