IS 250C V6-2.5L (4GR-FSE) (2011)
HINT
If primer is applied to an area that is not specified, wipe off the primer with a non-residue solvent before it dries.
(b) Align the notch of a new back window upper outside moulding with the paint mark of the back window lower outside.
Text in Illustration
NOTICE:
*
Allow the primer to dry for 3 minutes or more.
*
Do not keep any of the opened Primer G for later use.
*
Do not apply too much primer.
(c) Remove the release paper carefully from the center to the ends, then align the back window lower outside moulding with the back window
upper outside moulding (*a) and install the back window upper outside moulding.
HINT
*
Make sure that the ends of the moulding do not stick out beyond the corners of the back window glass.
*
Make sure to press the moulding firmly after installation.
5. INSTALL REMOVABLE ROOF GARNISH LH
(a) Clean the vehicle body surface.
(1) Wipe off any residue of butyl tape or double-sided tape from the back window frame upper sub-assembly installation surface.
(b) Align a new removable roof garnish LH with the alignment positions of the back window frame upper sub-assembly.
Text in Illustration