IS 300 L6-3.0L (2JZ-GE) (2001)
/Page-1337002.png)
8. REMOVE CENTER PILLAR LOWER GARNISH
a. Using a screwdriver, remove the center pillar lower garnish.
HINT: Tape the screwdriver tip before use.
b. Employ the same manner described above to the other side.
9. REMOVE FRONT SEAT OUTER BELT SHOULDER ANCHOR
a. Using a screwdriver, remove the anchor cap.
HINT: Tape the screwdriver tip before use.
b. Remove the bolt and front seat outer belt shoulder anchor.
Torque: 41 N.m (420 kgf.cm, 30 ft.lbf)
c. Employ the same manner described above to the other side.
10. REMOVE CENTER PILLAR GARNISH
a. Using a screwdriver, remove the center pillar garnish.
HINT: Tape the screwdriver tip before use.
b. Employ the same manner described above to the other side.
