IS 300 L6-3.0L (2JZ-GE) (2001)
Alignment: Service and Repair
Front Wheel Alignment
INSPECTION
1. MEASURE VEHICLE HEIGHT
Vehicle height (Canada)
Vehicle height (Except Canada)
Measuring points:
A: Ground clearance of the front No. 1 lower suspension arm mounting bolt center.
B: Ground clearance of the front wheel center.
C: Ground clearance of the rear wheel center.
D: Ground clearance of the No. 2 lower suspension arm mounting bolt (Suspension member side) tail center.
Vehicle height:
Front: B - A
Rear: C - D
NOTICE: Before inspecting the wheel alignment, adjust the vehicle height to the specified value.
If the vehicle height is not the specified value, try to adjust it by pushing down on or lifting the body.
2. INSTALL CAMBER-CASTER-KINGPIN GAUGE OR POSITION VEHICLE ON WHEEL ALIGNMENT TESTER
Follow the specific instructions of the equipment manufacturer.
3. INSPECT CAMBER, CASTER AND STEERING AXIS INCLINATION
Camber, caster and steering axis inclination (Canada)